how to use hot water bottle
Leave a message
How to Use Hot Water Bottle
In life, we often use hot water bags to warm ourselves. There are probably two kinds of hot water bags, rubber hot water bags and electric hot water bags. No matter what kind of hot water bags we use, we should pay attention to safety so as to avoid scalding.
rubber hot water bag
1. Unscrew the plug from the hot water bottle. Your water bottle will most likely already be in it's cover, and will have a plug at the top of the bottle that prevents water from spilling out. Start by unscrewing the plug so that you can fill it with water.
2. Allow water to heat up. You can use water from your tap, but often times that doesn't get hot enough for your water bottle. However, boiling water from a tea kettle is much too hot for a water bottle. Try not to exceed 100 degrees Fahrenheit or 42 degrees Celsius with your water.
3. Fill your bottle with water, about two thirds full. This step must be done carefully, because you don't want to burn yourself with hot water. If you are using a tea kettle, slowly pour water into your hot water bottle, allowing it to fill about two thirds full. If you are using a faucet, turn it off once it becomes hot, then line the opening of the water bottle up with the faucet. Turn it back on slowly, so that the water pressure doesn't spray onto your hands.
4. Remove your bottle from the water source. Once your bottle is mostly filled up (you don't want it filled to the top because you'll need a little space to squeeze out some of the air and a full water bottle may spill easily) slowly turn your faucet off. Then carefully remove the bottle from under the faucet, making sure you don't spill any of the water.
5. Squeeze air from the water bottle. Make sure your water bottle is standing upright, with the bottom touching a flat surface. Then, slowly press the sides of the water bottle, expelling air from the bottle. Do this until you see the water in the bottle rise to the opening of the bottle.
6. Screw the plug back into the hot water bottle. After you have expelled air from the water bottle, screw the topper back into the water bottle, making sure it is tight. Twist the plug until it can't be twisted anymore and then to test it, slowly turn the water bottle upside down to see if any water comes out.
7. Empty your bottle after use. Empty your water bottle out after the water has cooled and hang it upside down to dry, leaving the opening unplugged. Before using your water bottle again, check for leaks or damages by filling it with cold water.
Note
- Not suitable for children under the age of 36 months.
- Fill maximum capacity 2/3 water to keep safe.
- To be more safety, the temperature of the hot water should not exceed 80 degrees Celsius.
- When filling, hold the bottle in an upright position and fill slowly to avoid the hot water splashing back.
- The bottles should be replaced after two years of use.
- check stopper for wear and tear damage at regular intervals.
- Please pour out the water from hot water bottle when not in use.
- Do not heat it in the microwave oven.
electrci hot water bag
1. Preparation: 1 funnel, water plug, soda / green tea beverage bottle (500ml).
2. Fill the drink bottle with water (ordinary tap water) and tighten the funnel on the mouth of the bottle.
3. Locate the water injection port and pull the hot water bottle apart on both sides.
4. Insert the funnel and start water injection (it is normal for a small amount of water to overflow; wipe off after water injection).
5. Generally, 2 bottles (about 1000ml) of water can be injected or the water level can be below the water injection port. 6. Finally, squeeze the air out of the hot water bag and plug the water into the water injection port (be sure to tighten it).
Warm tips:
electric hot water bags must be zipped and pulled down after each charge. It's not safe.
Automatic temperature control, Avoid overheat
Disposable water injection, permanent use
Voltage: 220V, 500W, 50Hz
The charging time of 20 minutes, you can use the 2-8 hours
According to the different environment temperature, the use of time are also different






